| Most viewed - DIY Vacuum degassing chamber project |
Gasket sealant for sticking the silicone tube to the rim of the chamber235 viewsFlashGordoll
|
|
8 mm copper tube silver soldered to vacuum chamber for mounting the vacuum plumbing143 viewsFlashGordoll
|
|
|
3 inlets are supplied with the pump, I ordered a 3/8 SAE 6mm bore hose fitting131 viewsFlashGordoll
|
|
Thickened edge cleaned with angle grinder sanding disc, edge now measures between 5.5 and 6.5 mm121 viewsFlashGordoll
|
|
|
|
Under view of chamber gasket with Lexan lid119 viewsFlashGordoll
|
|
|
Rear view of Vacuum pump/oil sight glass115 viewsFlashGordoll
|
|
Inside of chamber ground/cleaned with 36 grit angle grinder sanding discs111 viewsFlashGordoll
|
|
All these 5X parts will be attached to the vacuum chamber, still waiting for the tail end to fit the vacuum hose105 viewsFlashGordoll
|
|
|
Copped propane tank, dimensions are 375mm diameter X 405mm height103 viewsFlashGordoll
|
|
Chopped down the cylinder to 16 inches height, a 2mm mild steel plate with be welded to the bottom for the base95 viewsFlashGordoll
|
|
|
6 CFM vacuum pump with 3 X different inlet threads73 viewsFlashGordoll
|
|
A propane tank (cut off top) the starting point of the vacuum chamber72 viewsFlashGordoll
|
|
|
|
|
|
|
